Remove the pattern by ironing
In fact, the simple way is to use an electric iron but to ensure that the custom T shirt is pure cotton, otherwise, it will not necessarily have an effect, it will greatly damage the fabric of the custom T shirt!
Lay the custom T shirt in a flat place, try not to have wrinkles. Ensure that the printed part is flat, and then iron repeatedly with the iron, the print will fall off!
If there is no effect at the beginning, you can stay on the print for a while. If you don’t have an iron, you can try to use a bottle to install hot water and press it on the print. Of course, the effect is not as good as the iron, and it won’t be so fast, but you can try it.
Use a sly method to remove the pattern
Although it is lightly rubbed, the purpose is to remove the pattern and it is violent. You can put the custom T shirt in warm water for a while, then the hard-printed part will be fine, usually, You can smash the print.
If you have no effect, try the brush. Repeated brushing of the printed part can also be used to brush down the print pattern, which is very effective against the general print pattern! However, brushing and smashing may cause the T shirt to be deformed. If it is a custom T shirt with a high price, don’t try it easily!
Remove the pattern with a wide tape
The first is to need a roll of sticky tape. If the stickiness is generally useless, you can use a hair dryer to heat the pattern to be removed, then rub it, so that the glue on the top becomes soft and then taped. The printed pattern is pressed against the pressure, which will make the print and tape more conformable.
Wait a little while, for a few seconds, then quickly tear off the tape from one side, it is from top to bottom, tearing from top to bottom, it is easier to remove the print, then repeat the above method to put all the Print patterns are all removed!
Remove the pattern with banana water/gasoline/alcohol
If the above method does not completely remove the print on the T shirt, then the chemical method is used. Because the print is a chemical similar to paint, it can be removed according to its chemical properties using banana water or gasoline or alcohol.
You can use a little banana drop in the place where there is a print and then wait for more than 5 minutes. Then wash the print with detergent or enzyme wash detergent until the print is completely removed, rinsed, and dried.
Banana water can also be replaced by alcohol or gasoline. But be sure to pay attention to safety! Because these three solutions are very flammable!
